This is the concealed hanger that holds your wall cabinets to the wall, fitted inside the cabinet where it stays out of sight once the doors are closed. It is specified for Mastercraft kitchen designs on wall units, giving you a clean finish with no visible brackets or plates. Side, height and depth adjustment mean each cabinet can be lined up precisely during fitting, so your run of wall units sits level and tight to the wall.

Key Benefits

• Fully concealed once installed, so there is nothing to see inside the cabinet or on the wall behind it, just a clean finish.
• Two way adjustment lets your fitter fine tune the cabinet position after hanging, which matters if a wall is not quite flat or a run of units needs to line up exactly.
• Side adjustment of 16 mm, height adjustment of 15 mm and depth adjustment of 16 mm give enough movement to correct small discrepancies without taking the cabinet down again.
• Zinc plated steel construction is chosen for its resistance to corrosion, which matters for a fitting that sits inside a cabinet for the life of your kitchen.
• Available with a short or long base plate and in left or right versions, so your installer can choose the right configuration for each cabinet.
• Load bearing capacity is tested to DIN EN 15939, giving a clear and consistent standard for how much weight the hanger is rated to carry.

There are two installation points worth knowing before fitting. The short base plate version must be fitted in the upper third of the cabinet for safety, with the safety lock screws driven in at a 45 degree angle, and the supporting arm pulled out fully before hooking the cabinet in place. The long base plate version is also screwed to the top panel of the cabinet, which gives it a higher load bearing capacity, so it suits cabinets carrying more weight or deeper cabinets where extra support is useful.

What's Included

• 1 cabinet hanger
• 2 cover caps

Specifications

• Material: Steel, zinc plated
• Application: Hanging wall units
• Load bearing capacity: 130 kg per pair (short base plate version), tested to DIN EN 15939
• Adjustment: Side 16 mm, height 15 mm, depth 16 mm, with further height and depth adjustment via 12 mm drill holes
• Options: Short base plate or long base plate, left or right fitting