This is a rectangular 90 degree bend from Manrose, designed to change the direction of your cooker hood ducting as it runs vertically, often tucked above kitchen cupboards where a straight run simply is not possible. Measuring 204 x 60mm, it uses female connections at both ends so it fits into a rigid ducting system without needing extra adaptors. It is a small but important part of getting extracted air out of your kitchen efficiently.

Key

Benefits

• Allows your ducting to turn a corner cleanly above cupboards, which matters when your cooker hood outlet does not line up directly with an external wall or vent.
• Rigid construction holds its shape over time, unlike flexible ducting which can sag or kink and reduce airflow.
• Female connections at each end make it straightforward to join with matching rigid ducting sections during installation.
• White finish suits ducting runs where any visible section sits within a white kitchen scheme.
• Backed by a 3 year manufacturer guarantee, giving you confidence in a part that is usually hidden away and hard to replace once cabinets are fitted.

Every bend in a ducting run adds a small amount of resistance to airflow, and this one is no exception. At lower flow rates the resistance is minimal, but it increases as the volume of air passing through rises. This is worth bearing in mind if your cooker hood ducting run already includes several bends, as the cumulative effect can reduce overall extraction performance. Your kitchen designer can factor this into the ducting layout to keep your extraction working as it should.

Specifications

• Type: Adaptor (rectangular vertical 90 degree bend)
• Dimensions: 204 x 60mm
• Colour: White
• Connections: Female to female
• Packaged weight: 5kg
• Manufacturer guarantee: 3 years
• Airflow resistance: 1.1Pa at 8l/