This is a flat 90° horizontal ducting bend, used to route extraction ducting from your cooker hood through a wall or cabinet run where the ductwork needs to change direction. It's a small but important part of the extraction system, chosen by Mastercraft Kitchens to keep ducting runs neat and efficient behind cabinetry.

Flat ducting like this is often used where depth is limited, such as above wall units or within tight cabinet voids, since it takes up less space than round ducting while still allowing air to flow through effectively. The bend's shape is designed to keep air moving smoothly, which matters because sharp turns or poorly shaped ducting can slow extraction and make your cooker hood work harder than it needs to.

Key

Benefits

• Aerodynamically shaped to reduce pressure loss, helping your extractor perform as intended rather than fighting resistance in the ductwork.
• Low profile flat design suits kitchens where duct depth is restricted, such as behind cabinets or above worktops.
• Easy to cut and connect using the female connector sleeve, making it straightforward to fit during installation.
• Black finish available where the ducting may be partially visible, keeping the look discreet rather than drawing attention.
• A compact, lightweight component that fits easily into existing cabinet or wall cavities without adding bulk.

Specifications

• Type: Ducting Kit component (90° flat horizontal bend)
• Height: 89mm
• Width: 222mm
• Depth: 293mm
• Material: Black plastic
• Packaged weight: 1kg
• Manufacturer's guarantee: 1 year